Operating Modes; Selection Of Operating Modes - Thermo Scientific Microm HM355S Operation Manual

Operating Modes

Selection of Operating
Mode Selection via
MODE-Button
Thermo Fisher Scientific
Automatic return movement can be stopped by briefly turning knob [B]
in the opposite direction.
The coarse feed motor turns off after having reached the back end position.
Cutting movements can either be started by pressing the button
START/STOP [7] twice, by stepping on the foot pedal (optional), or by
pressing knob [C].
When the specimen orientation is in the front end position, the red
LED arrow (pointing downward) on the operating panel starts blinking.
When the specimen orientation is in the back end position, the red
LED arrow (showing upward) on the operating panel starts blinking.
Press the knob [B] to release trim feed with the selected value, even if
the fine mode is active.
For the motorized cutting movement of the microtome, the following
operating modes are available:
– interval stroke
– single stroke
– multi stroke
– continuous stroke
The operating mode can be selected in two ways:
Modes
• directly with the MODE-button [8]
• over Menu by using knob [A]
• Press the MODE-button [8] gradually to change among the
4 different operating modes
Note!
When selecting multi stroke via the MODE-button [8], the default value of
sections is 2. To change this default value, please see page 35.
Operating Instructions
Display and Key Functions
Operation Manual HM335S 33