Table of Contents
Advertisement
Conditions for Transportation
Returning the Instrument
returning the Instru-
ment for repair or
routine Maintenance
Measures for Taking
out of Operation
For Transporting Outside Closed
Buildings, please Observe
the Following Measures
68
Operation Manual HM335S
Chapter 6
Conditions for Transportation
Repair or maintenance works is normally carried out at the site of ins-
tallation. If this is not possible for some specific reasons, the instrument
can be returned to ThermoFisher Scientific. The contact address can be
found in the front of this instruction manual.
To guarantee a trouble-free function of the instrument after transporta-
tion, please follow the instructions for transportation preparations.
In addition, the conditions for storage and transportation as mentioned
in the Technical Data Sheet (see page 16), must be observed during the
entire transportation.
B
iohazard
Please also note the precautionary measures described in our safety pre-
cautions concerning biological hazards!
•
Turn off the mains switch of the instrument.
•
Activate the mechanical hand wheel brake.
•
Remove knife or blade and store it in a safe place.
•
Remove the section waste tray.
•
Turn off the mains switch of the instrument.
•
Activate the mechanical hand wheel brake.
•
Remove knife or blade and store it in a safe place.
•
Remove the section waste tray, the operating panel, the
knife/blade carrier and the specimen clamp. These parts have to be
packed separatly.
•
To lift the instrument, use the recessed grip on the lower front and
rear side of the instrument.
c
!
aution
During transport, do not move the instrument by holding the hand
wheel handle. Danger of injury!
Thermo Fisher Scientific
Hide quick links:
Advertisement
Table of Contents
