Hyundai NextGen User Manual page 6

 Do not aim the camera lens at the strong light such as sun or incandescent lamp. The
strong light can cause fatal damage to the camera.
 The sensor may be burned out by a laser beam, so when any laser equipment is being
used, make sure that the surface of the sensor not be exposed to the laser beam.
Do not place the camera in extremely hot, cold temperatures (the operating temperature
should be between -30°C to +60°C, or -40°C to +60°C if the camera model has an "H"
in its suffix), dusty or damp environment, and do not expose it to high electromagnetic
radiation.
 To avoid heat accumulation, ensure there is good ventilation to the device.
 Keep the camera away from water and any liquids.
 While shipping, pack the camera in its original, or equivalent, packing materials. Or
packing the same texture.
 Improper use or replacement of the battery may result in hazard of explosion. Please use
the manufacturer recommended battery type.
Notes:
For the camera supports IR, you are required to pay attention to the following precautions to
prevent IR reflection:
 Dust or grease on the dome cover will cause IR reflection. Please do not remove the
dome cover film until the installation is finished. If there is dust or grease on the dome
cover, clean the dome cover with clean soft cloth and isopropyl alcohol.
 Make certain the installation location does not have reflective surfaces of objects too
close to the camera. The IR light from the camera may reflect back into the lens causing
reflection.
 The foam ring around the lens must be seated flush against the inner surface of the bubble
to isolate the lens from the IR LEDS. Fasten the dome cover to camera body so that the
foam ring and the dome cover are attached seamlessly.
Network Camera User Manual
5