Hyundai NextGen User Manual page 145

Road traffic function varies according to different camera models.
Note:
 Detection Configuration
Steps:
1. Select the detection type from the list. Vehicle Detection and Mixed-traffic Detection
are selectable.
Note: Reboot the device to activate the new settings when switching the detection type of
road traffic.
2. Check the checkbox of Enable to enable the selected detection function.
3. Select the lane number in the corresponding dropdown list. Up to 4 lanes are selectable.
4. Click and drag the lane line to set its position, or click and drag the line end to adjust
the length and angle of the line.
5. Adjust the zoom ratio of the camera so that the size of the vehicle in the image is close
to that of the red frame. Only the position of red frame is adjustable.
Only 1 license plate can be captured at one time for each lane.
Note:
6. Select a Province/State Abbreviation in the dropdown list when the attribution of
license plate cannot be recognized.
7. Set the Arming Schedule.
1) Click Arming Schedule to enter the arming schedule interface.
2) Click on the time bar and drag the mouse to select the time period.Click delete or
delete all to delete the configured schedule.
3) Move the mouse to the end of each day, a copy dialogue box pops up, and you can
copy the current settings to other days.
4) Click Save to save the settings.
Note: The time of each period cannot be overlapped. Up to 8 periods can be configured
for each day.
8. Set the linkage method. Notify surveillance center and upload to FTP/Memory
Card/NAS are selectable.
Notify Surveillance Center: Send an exception or alarm signal to remote
•
management software when an event occurs.
Network Camera User Manual
145