Configuring Line Crossing Detection - Hyundai NextGen User Manual

2. Check the checkbox of Enable Intrusion Detection to enable the function.
3. Select the region from the drop-down list for detection settings.
4. Click Area Settings tab and click Draw Area button to start the region drawing.
5. Click on the live video to specify the four vertexes of the detection region, and right
click to complete drawing.
6. Set the time threshold, detection sensitivity and object percentage for intrusion
detection.
Threshold: Range [0s-10s], the threshold for the time of the object loitering in the
region. If you set the value as 0, alarm is triggered immediately after the object entering
the region.
Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the object
which can trigger the alarm. When the sensitivity is high, a very small object can trigger
the alarm.
Percentage: Range [1-100]. Percentage defines the ratio of the in-region part of the
object which can trigger the alarm. For example, if the percentage is set as 50%, when
the object enters the region and occupies half of the whole region, the alarm is triggered.
7. Repeat the above steps to configure other regions. Up to 4 regions can be set. You can
click the Clear button to clear all pre-defined regions.
8. Click Arming Schedule to set the arming schedule.
9. Click Linkage Method to select the linkage methods for intrusion detection, including
Notify Surveillance Center, Send Email, Upload to FTP/Memory Card/NAS, Trigger
Channel and Trigger Alarm Output.
10. Click Save to save the settings.

10.2.6 Configuring Line Crossing Detection

Purpose:
Network Camera User Manual
119