Configuring Region Entrance Detection - Hyundai NextGen User Manual

on the line, two red squares are displayed on each end, and you can click-and-drag one
of the red squares to define the shape and length of the line.
6. Select the direction for line crossing detection. And you can select the directions as
A<->B, A ->B, and B->A.
A<->B: Only the arrow on the B side shows; when an object going across the plane with
both direction can be detected and alarms are triggered.
A->B: Only the object crossing the configured line from the A side to the B side can
be detected.
B->A: Only the object crossing the configured line from the B side to the A side can
be detected.
7. Click-and-drag the slider to set the detection sensitivity.
Sensitivity: Range [1-100]. The higher the value is, the more easily the line crossing
action can be detected.
8. Repeat the above steps to configure other lines. Up to 4 lines can be set. You can click
the Clear button to clear all pre-defined lines.
9. Click the Arming Schedule to set the arming schedule.
10. Select the linkage methods for line crossing detection, including Notify Surveillance
Center, Send Email, Upload to FTP/Memory Card/NAS, Trigger Channel and Trigger
Alarm Output.
11. Click Save to save the settings.

10.2.7 Configuring Region Entrance Detection

Purpose:
Region entrance detection function detects people, vehicle or other objects which enter a
pre-defined virtual region from the outside place, and some certain actions can be taken when
the alarm is triggered.
Steps:
1. Enter the Region Entrance Detection settings interface, Configuration > Event >
Smart Event > Region Entrance Detection.
Network Camera User Manual
121