Hyundai NextGen User Manual page 32

PBC Mode:
PBC refers to the Push-Button-Configuration, in which the user simply has to push a button,
either an actual or virtual one (as the
the IE browser), on both the Access Point (and a registrar of the network) and the new
wireless client device.
1. Check the checkbox of
2. Choose the connection mode as PBC.
Note: Support of this mode is mandatory for both the Access Points and the connecting
devices.
3. Check on the Wi-Fi router to see if there is a WPS button. If yes push the button and you
can see the indicator near the button start flashing, which means the WPS function of the
router is enabled. For detailed operation, please see the user guide of the router.
4. Push the WPS button to enable the function on the camera.
If there is not a WPS button on the camera, you can also click the virtual button to enable the
PBC function on the web interface.
5. Click Connect button.
When the PBC mode is both enabled in the router and the camera, the camera and the
wireless network is connected automatically.
PIN Mode:
The PIN mode requires a Personal Identification Number (PIN) to be read from either a
sticker or the display on the new wireless device. This PIN must then be entered to connect
the network, usually the Access Point of the network.
Steps:
1. Choose a wireless connection on the list and the SSID is loaded automatically.
2. Choose Use route PIN code.
Network Camera User Manual
button on the configuration interface of
to enable WPS.
31