Hyundai NextGen User Manual page 137

Network Camera User Manual
faster the target will be recognized. Setting the value quite low, and if there was a face in the
configured area from the start, this face will not be captured. It can reduce the misinformation
of the faces in the wall painting or posters. The default value of 3 is recommended.
Capture Times [1~10]: Refers to the capture times a face will be captured during its stay in
the configured area. The default value is 1.
Sensitivity [1~5]: The sensitivity to identify a target. The higher the value, the easier a face
will be recognized, and the higher misinformation is. The default value of 3 is recommended.
Capture Interval [1~255 Frame]: The frame interval to capture a picture. If you set the value
as 1, which is the default value, it means the camera captures the face in every frame.
Capture Sensitivity [0~20]: The threshold the camera treats the target as a face. Only when
the face score generated by the algorithm is equal or higher than the value, the camera will
treat the target as a face. The default value of 2 is recommended.
Face Capture Advanced Parameters:
Face Exposure: Check the checkbox to enable the face exposure.
Reference Brightness [0~100]: The reference brightness of a face in the face exposure
mode. If a face is detected, the camera adjusts the face brightness according to the value you
set. The higher the value, the brighter the face is.
Minimum Duration [1~60min]: The minimum duration of the camera exposures the face.
The default value is 1 minute.
Note: If the face exposure is enabled, please make sure the WDR function is disabled, and
the manual iris is selected.
Enable Face ROI: If the camera captures a face, the face area will be treated as the region
of interest, and the image quality of this area will be improved.
Restore Default: Click Restore to restore all the settings in advanced configuration to the
factory default.
137