Removing The Delivery Motor (M2) - Canon Staple Finisher-S1 Service Manual

4
Parts Replacement and Cleaning Procedure > Motors > Removing the Delivery Motor (M2) > Procedure
NOTE: How to install the Paddle Motor
Be sure to place the sheet [5] of the Paddle Motor between the gear [6] and the sensor [7]
when assembling.
[6]
[7]
[5]
4 Parts Replacement and Cleaning Procedure > Motors > Removing the Delivery Motor (M2) > Procedure
[7]
[6]
[5]
F-4-119

Removing the Delivery Motor (M2)

■ Preparation
1) Remove the Finisher Unit from the connected equipment(Refer to page 4-9).
2) Remove the Rear Cover(Refer to page 4-16).
■ Procedure
1) Remove the Delivery Motor [1].
• 2 Screws [2]
• 1 Belt [3]
• 1 Connector [4]
2x
[3]
[2]
4-45
F-4-120
1x
[1] [4]
F-4-121
4-45