Canon Staple Finisher-S1 Service Manual page 87

4
Parts Replacement and Cleaning Procedure > Motors > Removing the Stack Tray Shift Motor (M8) > Procedure
2) Remove the E-ring [1], the gear [2] and the Parallel Pin [3], and lower the Stack Tray Unit [4].
CAUTION:
When the gear [2] is removed, the Stack Tray Unit [4] will lower. Be sure to support the
Stack Tray Unit while performing the work
[2]
[4]
[1] [2] [3]
4 Parts Replacement and Cleaning Procedure > Motors > Removing the Stack Tray Shift Motor (M8) > Procedure
[4]
[4]
F-4-134
[4]
F-4-135
3) Remove the Stack Tray Shift Motor Unit [1]
• 3 Screws [2]
• 1 Shaft [3]
3x
[2]
NOTE: How to install the Stack Tray Shift Motor
When tightening the 3 screws [2], be sure that the clearance [A] between the Support
Plate of the motor and the Rear Plate becomes approx. 0.5 mm to 1.0 mm.
[A]
4-50
[3]
[1]
F-4-136
[2]
3x
[2]
F-4-137
4-50