Removing The Feed Motor (M1) - Canon Staple Finisher-S1 Service Manual

4
Parts Replacement and Cleaning Procedure > Motors > Removing the Feed Motor (M1) > Procedure

Removing the Feed Motor (M1)

■ Preparation
1) Remove the Finisher Unit from the connected equipment(Refer to page 4-9).
■ Procedure
1) Turn over the Buffer Path Unit [1].
[1]
2) Disconnect the connector [1], open the Edge Saddle [2], and remove the 3 screws [3].
1x
1x
3x
[2]
[1]
4 Parts Replacement and Cleaning Procedure > Motors > Removing the Feed Motor (M1) > Procedure
F-4-110
F-4-111
[3]
F-4-112
3) Remove the Rear Plate Unit [1] of the Buffer Path Unit.
• 3 Bosses [2]
• 1 Bushing [3]
• 1 Belt [4]
[1]
[2] [2] [3]
4) Remove the Feed Motor Unit [1].
• 2 Stepped Screws [2]
• 1 Belt [3]
2x
[2]
4-43
[4]
F-4-113
[1]
[3]
F-4-114
4-43