Removing The Main Motor (M1); Replacement Procedure; Removing The Fixing Motor (M2) - Canon imageRUNNER 2545 Series Service Manual

4
Parts Replacement and Cleaning > PCB > Removing the Fixing Motor (M2) > Replacement Procedure

Removing the Main Motor (M1)

■ Replacement Procedure

1) Remove the rear cover (right).("Removing the Rear Cover (Right)"(page
2) Remove the rear cover (left).("Removing the Rear Cover (Left)"(page
3) Remove the right cover (upper rear).("Removing the Rear Right Cover (Upper)"(page
4-22).)
4) Remove the HVT PCB.("Removing the HVT PCB"(page
5) Remove the main motor.
- 4 screws
- 1 connector
x1
x4
4 Parts Replacement and Cleaning > PCB > Removing the Fixing Motor (M2) > Replacement Procedure
4-21).)
4-22).)
4-45).)
F-4-109

Removing the Fixing Motor (M2)

■ Replacement Procedure
1) Remove the rear cover (right).("Removing the Rear Cover (Right)"(page
2) Remove the rear cover (left).("Removing the Rear Cover (Left)"(page
3) Remove the right cover (upper rear).("Removing the Rear Right Cover (Upper)"(page
4-22).)
4) Remove the support plate.
- 1 relay connector
- 1 connector
- 1 screw
x1
x1
NOTE:
Because there is a screw on the backside of the relay connector, remove the relay
connector earlier.
4-49
4-21).)
4-22).)
F-4-110
4-49