Removing The Equipment; Layout Drawing; Removing The Finisher Unit From The Connected Equipment - Canon Staple Finisher-S1 Service Manual

4
Parts Replacement and Cleaning Procedure > Removing the Equipment > Removing the Finisher Unit from the Connected Equipment

Removing the Equipment

Layout Drawing

[1]
[3]
No. Parts Name
[1] Finisher Unit Product Configuration
[2] Buffer Path Unit Product Configuration
[3] Reinforcing Plate Cover Product Configuration
4 Parts Replacement and Cleaning Procedure > Removing the Equipment > Removing the Finisher Unit from the Connected Equipment
[2]
F-4-11
Main Unit Reference
(Refer to page 4-9)
(Refer to page 4-11)
(Refer to page 4-12)
T-4-11
Removing the Finisher Unit from the Connected
Equipment
CAUTION:
• When removing this equipment from the connected equipment, be sure to check that
the power of the connected equipment is OFF and the power plug is disconnected
from the outlet.
• When disassembling/assembling this equipment, be sure to remove it from the
connected equipment by following the procedure.
• If the IC Card Reader is installed, be sure to remove it beforehand.
• After performing disassembly/assembly, be sure to perform the operation check.
The machine recognizes that a finisher is installed by turning on the power, and
executing a print job or opening and then closing the Front Door of the Finisher Unit
4-9
F-4-12
F-4-13
4-9