Chapter 3
3) Remove the 3 screws [1] and detach the
upper cover [2].
F-3-66
3.2.5.4
Removing the
Offset Motor
1) Disconnect the connector [1].
2) Remove the guide [2] and remove the
harness [4] from the edge saddle.
3) Remove the 2 screws [5] and remove the
offset motor [6].
3-20
F-3-67
3.2.6 Stack Slide Motor
[1]
3.2.6.1
0008-1039
1) Open the front cover [1] of the finisher.
2) Pull the lever [2] and draw out the
finisher.
[3]
3) Remove the 2 screws [1] and detach the
[1]
[3]
Removing the
PCB Cover
[2]
F-3-68
[5]
[4]
[2]
0008-1036
[1]