4
Parts Replacement and Cleaning Procedure > External Cover/Internal System > Removing the PCB Cover > Procedure
NOTE: How to install the Upper Cover
When installing the Upper Cover, check that the Trailing Edge Sheet [5] can be seen
from the hole [A] of the Rear Plate as shown in the figure below.
4
Parts Replacement and Cleaning Procedure > External Cover/Internal System > Removing the PCB Cover > Procedure
[5]
[A]
■ Preparation
■ Procedure
F-4-40
Removing the PCB Cover
1) Remove the Finisher Unit from the connected equipment(Refer to page 4-9).
1) Remove the PCB Cover [1].
• 1 Screw [2]
1x
[2]
4-19
F-4-41
[1]
F-4-42
4-19