Canon Staple Finisher-S1 Service Manual page 76

4
Parts Replacement and Cleaning Procedure > Major Units > How to assemble the Process Tray Upper Unit (Front/Rear) and the Finisher Lower Feed Guide Unit > Procedure (How to install the Process Tray Upper Unit (Rear)
5) Push the Guide Plate [1] of the Process Tray Upper Unit (Rear) with your fingers and check
that there is some backlash.
If there is no backlash, perform steps 1 and 4 again.
4 Parts Replacement and Cleaning Procedure > Major Units > How to assemble the Process Tray Upper Unit (Front/Rear) and the Finisher Lower Feed Guide Unit > Procedure (How to install the Process Tray Upper Unit (Rear)
[1]
F-4-99
● [D] Adjusting the Position of the Sub Paddle (Rear) and the Finisher
Lower Feed Guide Unit
6) While holding the [A] part of the Finisher Lower Feed Guide Unit [1], tighten the 3 screws [2].
3x
[1]
[A]
[2]
7) Rotate the shaft [1] of the Sub Paddle Unit, and check that the 2 ends [3] of the paddle
each fit in the area [A] between the tops of ribs and the bottom of the groove of the Process
Tray Upper Unit (Rear) [2].
If they are not lower into grooves with the grooves, perform steps 1) to 6) again.
[2]
4-39
[2]
[2]
F-4-100
[1]
[3]
[A]
[3]
[3]
[A]
F-4-101
4-39