Removing The Process Tray Lower Unit - Canon Staple Finisher-S1 Service Manual

4
Parts Replacement and Cleaning Procedure > Major Units > Removing the Process Tray Lower Unit > Procedure

Removing the Process Tray Lower Unit

■ Preparation
1) Remove the Finisher Unit from the connected equipment(Refer to page 4-9).
2) Remove the Staple Cartridge(Refer to page 4-22).
3) Remove the Front Cover(Refer to page 4-15).
4) Remove the Rear Cover(Refer to page 4-16).
5) Remove the Upper Cover(Refer to page 4-17).
6) Remove the Paddle Motor (M3) (Refer to page 4-44).
7) Remove the Staple Unit(Refer to page 4-23).
8) Remove the Front Door Switch (S15) (Refer to page 4-53).
9) Remove the Finisher Lower Feed Guide Unit(Refer to page 4-27).
10) Remove the Process Tray Upper Unit (Front) by referring to "Removing the Process Tray
Upper Unit (Front/Rear)" (Refer to page 4-35).
11) Remove the Grate-shaped Guide(Refer to page 4-20).
12) Remove the Finisher Controller PCB(Refer to page 4-55).
4 Parts Replacement and Cleaning Procedure > Major Units > Removing the Process Tray Lower Unit > Procedure
F-4-102
■ Procedure
1) Remove the Process Tray Lower Unit [1].
• 4 Connectors [2]
• 2 Wire Saddles [3]
• 2 Screws [4]
• 2 Hooks [5]
[2]
1x
3x
2x
[2] [3]
2x
[4]
[1]
[5]
[2]
F-4-103
4-40
4-40