Remove The Paddle Motor (M3) - Canon Staple Finisher-S1 Service Manual

4
Parts Replacement and Cleaning Procedure > Motors > Remove the Paddle Motor (M3) > Procedure
NOTE: How to install the Feed Motor Unit
Hook the belt [3] on the gear [4] of the Feed Motor Unit [1] and apply tension to the belt
under the motor's own weight. Then, tighten the 2 Stepped Screws [2].
[4]
[3]
5) Remove the Feed Motor [1].
• 2 Screws [2]
2x
[1]
4 Parts Replacement and Cleaning Procedure > Motors > Remove the Paddle Motor (M3) > Procedure
2x
[1]
[2]
F-4-115
[2]
F-4-116

Remove the Paddle Motor (M3)

■ Preparation
1) Remove the Finisher Unit from the connected equipment(Refer to page 4-9).
2) Remove the Rear Cover(Refer to page 4-16).
■ Procedure
1) Remove the Paddle Motor [1].
• 1 Connector [2]
• 1 Wire Saddle [3]
• 2 Screws [4]
1x
1x
[3] [2]
4-44
F-4-117
[1]
2x
[4]
[4]
F-4-118
4-44