Removing The Front Alignment Motor (M4) - Canon Staple Finisher-S1 Service Manual

4
Parts Replacement and Cleaning Procedure > Motors > Removing the Front Alignment Motor (M4) > Preparation
NOTE: How to install the Delivery Motor
Be sure to hook the belt [3] on the gear [5] of the Delivery Motor [1] and tighten the
screws [2] at the position where tension is applied to the belt under the motor's own
weight when assembling.
[3]
[1]
[5]
4 Parts Replacement and Cleaning Procedure > Motors > Removing the Front Alignment Motor (M4) > Preparation
1x
[2]
F-4-122

Removing the Front Alignment Motor (M4)

■ Preparation
1) Remove the Finisher Unit from the connected equipment(Refer to page 4-9).
2) Remove the Staple Cartridge(Refer to page 4-22).
3) Remove the Front Cover(Refer to page 4-15).
4) Remove the Rear Cover(Refer to page 4-16).
5) Remove the Upper Cover(Refer to page 4-17).
6) Remove the Paddle Motor (M3) (Refer to page 4-44).
7) Remove the Staple Unit(Refer to page 4-23).
8) Remove the Front Door Switch (S15) (Refer to page 4-53).
9) Remove the Finisher Lower Feed Guide Unit(Refer to page 4-27).
10) Remove the Process Tray Upper Unit (Front) by referring to "Removing the Process Tray
Upper Unit (Front/Rear)" (Refer to page 4-35).
4-46
F-4-123
4-46