Canon Staple Finisher-S1 Service Manual page 24

2
Technology > Processing Tray Unit > Alignment / Shifting Operation
The relationship between operation modes and shifting positions is summarized in the
following table:
Operation Mode Paper Width
Non-Sort / Sort 210 mm or more • Front shift position: 10 mm frontward from the central
reference position (Same as the alignment position)
• Rear shift position 10 mm backward from the central
reference position (Same as the alignment position)
*: Shift amount: 20 mm
180 mm or more • Front shift position: F mm frontward from the central
to less than 210 reference position
mm F = 110 - ("Paper width" / 2)
• Rear shift position: R mm frontward from the central
reference position
R = 85 - ("Paper width" / 2)
*: Shift amount: 25 mm
139 mm or more • Front shift position: 10 mm frontward from the central
to less than 180 reference position
mm • Rear shift position: 10 mm backward from the central
reference position
*: Shift amount: 20 mm
Staple 203 mm or more • Front shift position: 10 mm frontward from the central
reference position
*: Shift amount: 20 mm
less than 203 mm Stapling position
NOTE:
In the non-sort mode, paper is aligned/shifted at the position which is different from the
position where paper was aligned/shifted at the end of the previous copy job.
2 Technology > Processing Tray Unit > Alignment / Shifting Operation
Shifting Position
T-2-5
● Alignment Operation in Non-sort / Sort Mode
(1) After lapse of the specified time since detection of paper by the Feed Path Sensor (S2),
the front and rear alignment plates move to the standby position (paper width + 10 mm).
Rear Alignment Plate
Half of Paper Width
+10mm
Middle of Feeding Path
Half of Paper Width
+10mm
Front Alignment Plate
2-13
F-2-17
2-13