Pcbs; Layout Drawing; Removing The Finisher Controller Pcb - Canon Staple Finisher-S1 Service Manual

4
Parts Replacement and Cleaning Procedure > PCBs > Removing the Finisher Controller PCB > Procedure

PCBs

Layout Drawing

PCB1
No. Parts Name
PCB1 Finisher Controller PCB
4 Parts Replacement and Cleaning Procedure > PCBs > Removing the Finisher Controller PCB > Procedure
F-4-148
Main Unit Reference
Product Configuration (Refer to page 4-55)
T-4-18

Removing the Finisher Controller PCB

■ Preparation
1) Remove the Finisher Unit from the connected equipment(Refer to page 4-9).
2) Remove the Staple Cartridge(Refer to page 4-22).
3) Remove the Front Cover(Refer to page 4-15).
4) Remove the Rear Cover(Refer to page 4-16).
5) Remove the Grate-shaped Guide(Refer to page 4-20).
■ Procedure
1) Disconnect the 13 connectors [2] on the Finisher Controller PCB [1] and the connector [3]
on the Support Plate.
• 5 Wire Saddles [4]
• 1 Edge Saddle [5]
6x
[4]
[5] [4] [1]
4-55
F-4-149
14x
[3] [2]
F-4-150
4-55