Canon Staple Finisher-S1 Service Manual page 75

4
Parts Replacement and Cleaning Procedure > Major Units > How to assemble the Process Tray Upper Unit (Front/Rear) and the Finisher Lower Feed Guide Unit > Procedure (How to install the Process Tray Upper Unit (Rear)
■ Procedure (How to install the Process Tray Upper Unit (Rear)
and the Finisher Lower Feed Guide Unit)
● [C] Adjusting the Position of the Guide Plate of the Process Tray
Upper Unit (Rear)
1) Loosen the 2 screws [2] of the Process Tray Upper Unit (Rear) [1] and the 3 screws [4] of
the Finisher Lower Feed Guide Unit [3].
[4]
5x
[4]
[2]
4 Parts Replacement and Cleaning Procedure > Major Units > How to assemble the Process Tray Upper Unit (Front/Rear) and the Finisher Lower Feed Guide Unit > Procedure (How to install the Process Tray Upper Unit (Rear)
[3]
[1]
[2]
F-4-97
2) Tighten the screw [2] while lifting the Process Tray Upper Unit (Rear) [1].
3) Move the Guide Plate [3] of the Process Tray Upper Unit (Rear) [1] in the direction of the
arrow until it stops.
4) While holding the [A] part of the Process Tray Upper Unit (Rear) [1] with your fingers,
tighten the 2 screws [4].
2x
[2]
[3]
4-38
[1]
[4]
[A]
F-4-98
4-38