Removing The Rear Alignment Motor (M5) - Canon Staple Finisher-S1 Service Manual

4
Parts Replacement and Cleaning Procedure > Motors > Removing the Rear Alignment Motor (M5) > Preparation
■ Procedure
1) Remove the Front Alignment Motor Unit [1].
• 1 Connector [2]
• 2 Wire Saddle [3]
• 2 Screws [4]
• 1 Belt [5]
• 1 Hook [6]
1x
[4]
[5]
2x
2x
2) Remove the Front Alignment Motor Unit [1] from the Front Alignment Motor.
• 2 Screws [3]
2x
[3]
[2]
4 Parts Replacement and Cleaning Procedure > Motors > Removing the Rear Alignment Motor (M5) > Preparation
[1]
[2]
[6]
[3]
F-4-124
[1]
[3]
F-4-125

Removing the Rear Alignment Motor (M5)

■ Preparation
1) Remove the Finisher Unit from the connected equipment(Refer to page 4-9).
2) Remove the Staple Cartridge(Refer to page 4-22).
3) Remove the Front Cover(Refer to page 4-15).
4) Remove the Rear Cover(Refer to page 4-16).
5) Remove the Upper Cover(Refer to page 4-17).
6) Remove the Paddle Motor (M3) (Refer to page 4-44).
7) Remove the Staple Unit(Refer to page 4-23).
8) Remove the Front Door Switch (S15) (Refer to page 4-53).
9) Remove the Finisher Lower Feed Guide Unit(Refer to page 4-27).
10) Remove the Process Tray Upper Unit (Rear) by referring to "Removing the Process Tray
Upper Unit (Front/Rear)" (Refer to page 4-35).
4-47
F-4-126
4-47