Canon Staple Finisher-S1 Service Manual page 65

4
Parts Replacement and Cleaning Procedure > Major Units > Removing the Finisher Lower Feed Guide Unit > Procedure
■ Procedure
CAUTION:
• When removing the Finisher Lower Feed Guide Unit [1], be sure to place it with the
sheet [2] up.
[2]
• When removing the Finisher Lower Feed Guide Unit, be sure to adjust the
installation position by referring to "How to assemble the Process Tray Upper Unit
(Front/Rear) and the Finisher Lower Feed Guide Unit".
4 Parts Replacement and Cleaning Procedure > Major Units > Removing the Finisher Lower Feed Guide Unit > Procedure
[1]
F-4-67
1) Remove the following parts from the Main Paddle Shaft [1].
• 2 E-rings [2]
• 1 Gear [3]
• 1 Bushing [4]
[1]
2) Turn the Sensor Flag [1] to provide access to the 4 [A] parts of the Main Paddle as shown
in the figure below.
[A]
[1]
4-28
[4]
[2]
[3]
[2]
F-4-68
[A]
F-4-69
4-28