Canon Staple Finisher-S1 Service Manual page 26

2
Technology > Processing Tray Unit > Alignment / Shifting Operation
(2) After lapse of the specified time since detection of the paper's trailing edge by the Feed
Path Sensor (S2), the front and rear alignment plates move to align paper.
• Alignment position of the center reference (in the case of the paper width being 200
mm or more, and top paper)
Half of Paper
Width
Middle of Feeding Path
Half of Paper
Width
NOTE:
When the paper length is 300 mm or more, alignment of the top paper executed at the
staple position as well.
• Alignment position of the staple position (in the case of the paper width being 200 mm
or more, and the second and subsequent sheets)
The position that aligns
paper by the front and
rear alignment plates
2mm
Front Alignment Plate Home Position
2 Technology > Processing Tray Unit > Alignment / Shifting Operation
Paper
F-2-22
Paper
F-2-23
• Staple alignment position (when the paper width is less than 200 mm)
The position that aligns
paper by the front and
rear alignment plates
+
dmm
2mm
Front Alignment Plate Home Position
NOTE:
The length d varies by the number of stacking papers on processing tray.
• If the number of sheets stacked is 1 to 3: 2.0 mm
• If the number of sheets stacked is 4 or more: 4.0 mm
2-15
Paper
F-2-24
2-15