6.2 Installation of the Hybrid IP-PBX — KX-TDA30
Wall Mounting (KX-TDA30)
Mounting on Wooden Wall
Place the reference for wall mounting (on the last page of this manual) on the wall to mark
the 3 screw positions.
Install the screws and washers (included) in the wall.
Drive the screw
to this position.
Make sure that the screw heads are at the same distance from the wall.
Install the screws perpendicular to the wall.
Hook the main unit on the screw heads.
Do not block the openings of the cabinet. Allow space of at least 20 cm above and 10
cm at the sides of the cabinet.
Make sure that the wall behind the cabinet is flat and free of obstacles, so that the
openings on the back of the cabinet will not be blocked.
Be careful not to drop the cabinet.