Bri2 Card - Panasonic KX-TDA30 Installation Manual

6.3 Installation of the Trunk Cards — KX-TDA30
6.3.5

BRI2 Card

Function
2-port ISDN Basic Rate Interface card with 1 power failure transfer (PFT) port. EURO-ISDN/
ETSI compliant.
RJ45 (LINE 1)
RJ45 (LINE 2)
To NT1/Extension
Accessory and User-supplied Items
Accessory (included): Extension Bolt × 1, Strap × 1
User-supplied (not included): RJ45 connector
Notes
• When connecting this optional service card to the trunk, connect through an NT1; do
not connect to the U interface of the trunk directly.
• This optional service card has 100
point connection, the card must be placed at the end of the bus.
• This optional service card can be used for either trunk or extension connection, by
setting the A/B switch or using the connector with appropriate pin assignments.
• For details about power failure transfer, refer to "6.11.1 Power Failure Connections".
• To confirm the trunk connection, refer to "Confirming the Trunk Connection" in "6.12.1
Starting the Hybrid IP-PBX".
Notice
If the connected ISDN terminal has no external power source, make sure that the power
is supplied from the BRI2 card by programming the Hybrid IP-PBX accordingly.
However, if there is an external power source to the terminal, make sure that there is no
power supplied to the terminal from the BRI2 card. Failure to do so may cause damage to
the power supply circuit of the BRI2 card or the terminal.
Switch Settings
Switch
A/B
286 Installation Manual
LED 1
LED 2
Type Usage and Status Definition
Slide Select A (default) for trunk or B for extension use.
A B A B
OR
of terminal resistance. For use in point to multi-