2.2 Installation of the Hybrid IP-PBX
2.2.8
Wall Mounting (KX-TDA600/KX-TDA620)
Mounting Shelves
CAUTION
•
Make sure that the wall the shelves will be attached to is capable of supporting at least 4 times the
weight of the shelves.
•
Drive mounting screws into the wall. Be careful to avoid touching any metal laths, wire laths or
metal plates in the wall.
Notes
•
Make sure to remove the front cover from each shelf before installing the shelves (refer to "2.2.3
Opening/Closing the Front Cover").
•
Do not install any optional service cards or a PSU in the shelves before installation.
•
Do not block the openings of the shelf. Allow space of at least 20 cm above and 10 cm at the sides
of the shelf.
•
Make sure that the surface behind the shelf is flat and free of obstacles, so that the openings on
the back of the shelf will not be blocked.
•
Make sure that the surface behind the shelf is not made of wood.
•
Be careful not to drop the shelf.
1.
Install 4 anchor plugs in the wall, using the metal bracket as a template. Fix the metal bracket with 4
screws (A).
Metal Bracket
Screw (A)
98
Installation Manual
Anchor Plug
WWW.ERTEBATGROUP.COM
W a ll
Hammer
Metal Bracket
WWW.ERTEBATGROUP.COM
Anchor Plug
30 mm
Screw (A)
8 mm