If cables are run on the floor, use protectors to prevent the wires from being stepped on.
Avoid wiring under carpets.
Avoid using the same power supply outlet for computers, telexes, and other office
equipment. Otherwise, the Hybrid IP-PBX operation may be interrupted by the inducted
noise from such equipment.
Please use 1-pair telephone wire for extension connection of (telephone) equipment such
as standard telephones, data terminals, answering machines, computers, Voice
Processing Systems, etc., except PTs (e.g., KX-T7600 series).
The power switch and battery switch of the Hybrid IP-PBX must be off during wiring. After
the wiring is completed, turn the power switch on.
Mis-wiring may cause the Hybrid IP-PBX to operate improperly.
If an extension does not operate properly, disconnect the telephone from the extension line
and then connect again, or turn the power to the Hybrid IP-PBX off and on again.
The Hybrid IP-PBX is equipped with a 3-wire earthing type plug. This is a safety feature.
If you are unable to insert the plug into the outlet, contact your electrician to replace your
obsolete outlet. Do not defeat the purpose of the earthing-type plug.
Use twisted pair cable for trunk connection.
Trunks should be installed with lightning protectors. For details, refer to "2.2.14 Lightning
2.1 Before Installation — KX-TDA100/KX-TDA200