6.12 Starting The Hybrid Ip-Pbx - Kx-Tda30; 6.12.1 Starting The Hybrid Ip-Pbx - Panasonic KX-TDA30 Installation Manual

6.12 Starting the Hybrid IP-PBX — KX-TDA30
6.12 Starting the Hybrid IP-PBX — KX-TDA30

6.12.1 Starting the Hybrid IP-PBX

CAUTION
• SD Memory Card must be inserted in the SD Memory Card slot of the main board
before start up.
• Before touching the System Initialise Switch and the Reset Button, discharge static
by touching ground or wearing an earthing strap.
• Once you have started the Hybrid IP-PBX and if you unplug the Hybrid IP-PBX, do
not perform the following procedures to start the Hybrid IP-PBX again. Otherwise,
your programmed data is cleared. To restart the Hybrid IP-PBX, refer to "8.1.4 Using
the Reset Button".
• The Hybrid IP-PBX will continue to be powered even if the power switch is turned
"OFF".
• The power supply cord is used as the main disconnect device, ensure that the socket-
outlet is located/installed near the equipment and is easily accessible.
1.
Set the System Initialise Switch to the "SYSTEM INITIALIZE" position.
RUN Indicator
ALARM Indicator
386 Installation Manual
Reset Button
System Initialise Switch