Connection Of Dect Portable Stations - Kx-Tda100/Kx-Tda200; Overview - Panasonic KX-TDA30 Installation Manual

2.8 Connection of DECT Portable Stations — KX-TDA100/KX-TDA200
2.8 Connection of DECT Portable Stations —
KX-TDA100/KX-TDA200
2.8.1

Overview

The following equipment is required to connect the wireless system:
CS: Cell Station (KX-TDA0142CE/KX-TDA0141CE)
KX-TDA0142CE Using a CSIF Card
This unit determines the area covered by the wireless system. Up to 4 calls can be made
at the same time through each CS.
• CSIF4 (KX-TDA0143)
One CSIF4 card supports up to 4 Cell Stations. Up to 2 CSIF4 cards can be
connected to the KX-TDA100, and up to 4 can be connected to the KX-TDA200.
• CSIF8 (KX-TDA0144)
One CSIF8 card supports up to 8 Cell Stations. Up to 2 CSIF8 cards can be
connected to the KX-TDA100, and up to 4 can be connected to the KX-TDA200.
KX-TDA0141CE Using a DHLC/DLC Card
This unit determines the area covered by the wireless system. Up to 2 calls can be made
at the same time through each CS.
Note for users in Europe
This Cell Station Unit for DECT is for connection to a Panasonic PBX of a European
country.
PS: DECT Portable Station (KX-TCA155/KX-TCA255/KX-TD7590/KX-TD7580)
The KX-TDA100 and KX-TDA200 can support up to 128 PSs. For more details about the PS,
please refer to the PS Operating Instructions.
RF Specification
Radio Access Method
Frequency Band
Number of Carriers
Carrier Spacing
Bit Rate
Carrier Multiplex
Frame Length
Modulation Scheme
Data Coding for Modulator
Voice CODEC
136 Installation Manual
Item
Multi Carrier TDMA-TDD
1880 MHz to 1900 MHz
10
1728 kHz
1152 kbps
TDMA, 24 (Tx12, Rx12) slots per frame
10 ms
GFSK
Roll-off factor=0.5
Differential Coding
32 kbps ADPCM (CCITT G.721)
Description
*1
*2
50 % roll-off in the transmitter