6.12 Starting the Hybrid IP-PBX — KX-TDA30
3.
Plug the AC cord into the AC adaptor, and then plug the other end into an AC outlet.
AC Adaptor
To AC outlet
4.
Turn on the power switch.
Notes
•
For safety reasons, follow the procedures as indicated when turning on the Hybrid IP-
PBX.
•
For safety reasons, do not stretch, bend, or pinch the AC cord and the DC cable of
the AC adaptor.
5.
Press the Reset Button with a pointed tool. (The RUN indicator will flash.)
6.
While the RUN indicator is flashing (within about 10 s), return the System Initialise Switch
to the "NORMAL" position. Depending on the configuration, initialisation takes about 1 min
to 3 min. If successfully executed, the RUN indicator will stop flashing and be kept lit.
All data will be cleared, and the Hybrid IP-PBX as well as all optional service cards (except for
the IP-GW4 card) will be initialised to the default values. The DPTs should show the time as
01:00.
The data of the IP-GW4 card will not be initialised.
Note
Use the same types of AC adaptor and AC cord that are supplied with the Hybrid IP-PBX
only.
388
Installation Manual
AC Cord
Power Switch