Installing The Kx-Tda30 Maintenance Console; Programming The Hybrid Ip-Pbx - Panasonic KX-TDA15 Getting Started

4.2

Installing the KX-TDA30 Maintenance Console

For the system requirements of the PC (e.g., operating system, hardware specifications), refer to
"3.3.1 Installing and Starting the KX-TDA30 Maintenance Console" in the Installation Manual.
Notes
• Make sure to install and use the latest version of the KX-TDA30 Maintenance Console.
• To connect the PC to the Hybrid IP-PBX via USB, the KX-TDA USB driver must be installed.
Follow the instructions of the wizard to install the KX-TDA USB driver. When the Hybrid IP-
PBX is first connected to the PC via USB, you may be asked to select the appropriate USB
driver. Browse for and select the KX-TDA USB driver that was installed previously.
• The contents and design of the software are subject to change without notice.
• Screen shots reprinted with permission from Microsoft Corporation.
4.3

Programming the Hybrid IP-PBX

Starting the KX-TDA30 Maintenance Console and Assigning the Basic
Items (Quick Setup)
When you start the KX-TDA30 Maintenance Console with the Installer Level Programmer Code and
connect to the Hybrid IP-PBX for the first time after initialisation (with the factory default setting),
Quick Setup will launch automatically. During Quick Setup, you will set up the basic items. For details
about the basic items, refer to "2.3.4 Quick Setup" in the Feature Guide.
4.2 Installing the KX-TDA30 Maintenance Console
1. Copy the setup file of the KX-TDA30 Maintenance
Console to your PC. (Its icon is shown here, on the left.)
2. Double-click the setup file to run the installer.
3. Follow the on-screen instructions provided by the
installation wizard.
1. Connect the PC to the Hybrid IP-PBX with a
USB cable or RS-232C.
2. Start the KX-TDA30 Maintenance Console
from the Start menu.
3. "Information before programming" appears.
a.
Carefully read this important additional
information, which includes updates to this
and other manuals.
b.
Click OK to close this window.
4. a.
Enter the Installer Level Programmer Code
(default: INSTALLER).
b.
Click OK.
Getting Started 23