Operation - Panasonic KX-TDA30 Installation Manual

8.1.3

Operation

PROBLEM
• When using the
speakerphone on an
APT, nothing is audible.
• When using the
speakerphone/monitor
mode with a DPT,
nothing is audible.
• The PT does not ring.
• During a power failure,
extensions connected to
ports 1 and 2 of Super
Hybrid Ports do not
operate.
• Originating an outside
call, call transfer, or
conference cannot be
performed.
• Cannot register the PS.
• PS becomes out of
range.
• Cannot make calls using
the PS.
PROBABLE CAUSE
• The HANDSET/
HEADSET selector is
set to the "HEADSET"
position.
• The "HEADSET" mode
is selected by Personal
Programming,
"Handset/Headset
Selection".
• The ringer volume is off. •
• A DPT or APT is
connected to the
extension port.
• The dialling mode (tone
or pulse) is incorrect.
• The corresponding CO
button does not exist on
the PT.
• Wrong Personal
Identification Number
(PIN) is registered to the
PS.
• CS is not connected
properly.
• CS is not working.
• Location of CS is not
good.
• Access system of the
PS is not properly set.
8.1 Troubleshooting — KX-TDA30
SOLUTION
• When the headset is not used, set the
HANDSET/HEADSET selector to the
"HANDSET" position.
• When the headset is not used, select
the "HANDSET" mode by Personal
Programming.
Turn on the ringer volume.
• Disconnect the DPT or APT and
connect an SLT.
• Set the Tone/Pulse switch to the other
position.
• Programme the CO button. Refer to
"1.19.2 Flexible Buttons" in the Feature
Guide.
• Register the PIN set to the Hybrid IP-
PBX into the PS.
• Make sure that the cable is connected
properly with correct pin assignments.
Also, make sure that the cable does not
make short circuits.
• Switch all DIP switches off.
• Make sure that the cable is connected
properly with correct pin assignments.
Also, make sure that the cable does not
make short circuits.
• Switch all DIP switches off.
• Locate the CS properly (refer to "6.7.5
Site Survey Using the KX-TCA255/KX-
TD7590" or "6.8.5 Site Survey" ).
• Change the access system setting of
the PS to the appropriate system or
automatic.
Installation Manual 407