Before Installation - Kx-Tda30; Before Installation - Panasonic KX-TDA30 Installation Manual

6.1 Before Installation — KX-TDA30
6.1 Before Installation — KX-TDA30
6.1.1

Before Installation

Please read the following notes concerning installation and connection before installing the
Hybrid IP-PBX. Be sure to comply with applicable local regulations (e.g., law, guidelines).
Safety Installation Instructions
When installing telephone wiring, basic safety precautions should always be followed to reduce
the risk of fire, electric shock and injury to persons, including the following:
1.
Never install telephone wiring during a lightning storm.
2.
Never install telephone jacks in wet locations unless the jack is specifically designed for
wet locations.
3.
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
4.
Use caution when installing or modifying telephone lines.
5.
Anti-static precautions should be taken during installation.
Installation Precautions
This set is made for wall mounting. Avoid installing in the following places. (Doing so may result
in malfunction, noise, or discolouration.)
1.
In direct sunlight and hot, cold, or humid places.
Temperature range: 0 °C to 40 °C
2.
Sulphuric gases produced in areas where there are thermal springs, etc. may damage the
equipment or contacts.
3.
Places in which shocks or vibrations are frequent or strong.
4.
Dusty places, or places where water or oil may come into contact with the unit.
5.
Near high-frequency generating devices such as sewing machines or electric welders.
6.
On or near computers, telexes, or other office equipment, as well as microwave ovens or
air conditioners. (It is preferable not to install in the same room with the above equipment.)
7.
Closer than 1.8 m to radios and televisions (both the Hybrid IP-PBX and PTs).
8.
Do not obstruct the area around the Hybrid IP-PBX (for reasons of maintenance and
inspection—be especially careful to allow at least 20 cm above and 10 cm at the sides of
the Hybrid IP-PBX for cooling).
9.
Do not block the openings at top of the Hybrid IP-PBX.
10.
Do not stack up the optional service cards. To avoid damage to the optional service cards,
always use the extension bolts.
Wiring Precautions
Be sure to follow these instructions when wiring.
1.
Do not wire the telephone cable in parallel with an AC power source, computer, telex, etc.
If the cables are run near those wires, shield the cables with metal tubing or use shielded
cables and ground the shields.
2.
If cables are run on the floor, use protectors to prevent the wires from being stepped on.
Avoid wiring under carpets.
250 Installation Manual