Led And Wiring Information - Honeywell CDMA-X Installation And Setup Manual

LED and Wiring Information

LED
REG
(green)
TX/RX
(yellow)
FAULT
(red)
SIGNAL
STRENGTH
(green)
ALL
(except signal
strength green)
(BLINK = equal ON and OFF time; FLASH = brief ON, longer OFF time)
ON – Module is NOT registered with AlarmNet.
OFF – Module is registered with AlarmNet.
FAST BLINK – Download session with Compass in progress.
SLOW BLINK – In unison with yellow LED – Registration in progress.
PERIODIC FLASH – module has been deactivated in network coverage
ON – Message transmission pending.
QUICK PERIODIC BLINK - Normal
FAST BLINK – Message waiting for network ACK.
SLOW BLINK – In unison with green LED – Registration in progress.
PERIODIC BLINK – Module has been deactivated in roaming coverage
ON – No contact with network.
OFF– Normal.
SLOW BLINK – Loss of communication with the panel (ECP fault).
FAST BLINK – No network contact AND loss of communication with the control panel.
PERIODIC FLASH – Module has been deactivated in roaming coverage
ON – Minimum required signal strength is present.
OFF – Installation is not recommended.
FAST BLINK sequential – Over the air (OTA) firmware update in process
DESCRIPTION