Parameter Clear / All Parameter Clear - Mitsubishi Electric FR-CS84-012 Instruction Manual

5.13

Parameter clear / All parameter clear

NOTE
• Set "1" to Pr.CL Parameter clear or ALLC All parameter clear to initialize parameters. (Parameters cannot be cleared when
Pr.77 Parameter write selection = "1".)
• Pr.CL does not clear calibration parameters or the terminal function selection parameters.
• Refer to the parameter list on
Operating procedure
1.
Turning ON the power of the inverter
The operation panel is in the monitor mode.
2.
Selecting the parameter setting mode
Press to choose the parameter setting mode.
3.
Selecting the parameter
Press or
and press . "
4.
Parameter clear
Press or
("
• Press or
• Press to show the setting again.
• Press twice to show the next parameter.
Setting
0 Initial display (Parameters are not cleared.)
The settings of parameters except for calibration parameters
1
and terminal function selection parameters are initialized.
NOTE
• Stop the inverter first. Writing error occurs if parameter clear is attempted while the inverter is running.
To clear parameters, the inverter must be in the PU operation mode even if "2" is set to Pr.77.
• For availability of the Parameter clear or All parameter clear operation for each parameter, refer to the parameter list on
386.
page 386 for parameters to be cleared with this operation.
to display "
" (initial value) appears.
to change the set value to "
") are displayed alternately after parameters are cleared.
to read another parameter.
Pr.CL Parameter clear
" for Parameter clear or "
". Press to set. "
Description
ALLC All parameter clear
The settings of all the parameters, including calibration
parameters and terminal function selection parameters, are
initialized.
5.13 Parameter clear / All parameter clear
" for All parameter clear,
" and " "
page
203
5. PARAMETERS
2
2
3
4
5
6
7
8
9
10