Selecting a parameter by function group number to change its setting
The following shows the procedure to change the setting of
Turning ON the power of the inverter
The operation panel is in the monitor mode.
Selecting the parameter setting mode
Enabling the function group selection
Protective function parameter.
Selecting a parameter
Changing the setting value
5.1 Parameter list
to choose the parameter setting mode.
" will appear, which shows that the operation panel is ready for selection of a number in the group of
(initial value)" appears.
to change the set value to "
" are displayed alternately after the setting is completed.
P.H400 (Pr.1) Maximum frequency
" (Protective function parameter) appears. Press
P.H400 Maximum frequency
to confirm the selection.
) appears. Press
to display the present set
to confirm the selection. "