Remote Setting Function - Mitsubishi Electric FR-CS84-012 Instruction Manual

5.4.3

Remote setting function

Even if the operation panel is located away from the enclosure, contact signals can be used to perform continuous variable-
speed operation, without using analog signals.
Pr. Name
59 Remote function
F101 selection
 Remote setting function
• Use to enable/disable the remote setting function and enable/disable the frequency setting storage function during
Pr.59
remote setting.
• When ≠ "0" (remote setting function valid), the functions of the RH, RM and RL signals are changed to acceleration
Pr.59
(RH), deceleration (RM) and clear (RL).
Forward
Inverter
rotation
STF
Acceleration
RH
Deceleration
RM
Clear
RL
SD
Connection
di f t tti
 Acceleration/deceleration operation
• When the acceleration (RH) signal is turned ON, the set frequency increases. The increased speed at this time is
determined by the setting of
set frequency and run the motor at the frequency at that time.
• When the deceleration (RM) signal is turned ON, the set frequency decreases. The decreased speed at this time is
determined by the setting of
the same as
Pr.44
frequency at that time.
Main speed
Minimum
frequency
0
Forward rotation(STF)
Acceleration(RH)
Deceleration(RM)
96
5. PARAMETERS
5.4 (F) Setting of acceleration/deceleration time and acceleration/deceleration pattern
Initial Setting
value range
0
1
2
0
3
10
Set frequency
2
*1
5
Acceleration (RH)
Deceleration (RM)
Clear (RL)
Forward rotation (STF)
Power supply
*1 External operation frequency (other than multi-speed) or PU running frequency
Pr.44 Second acceleration/deceleration time
Pr.45 Second acceleration/deceleration time
setting. Turning OFF the RM signal stops decreasing the set frequency and runs the motor at the
ON
ON
RH, RM, RL signal
function
Multi-speed setting
Remote setting
Remote setting
Remote setting
0Hz
0
ON ON
ON
ON
Pr.59 = " 1, 2, 3"
Decelerates to the main speed
Time
ON
Description
Frequency setting
storage
—
Displayed
Not used
Not used
(Turning STF/STR OFF
clears remotely-set
frequency.)
When Pr.59 = " 1, 2"
When Pr.59 = " 3"
When Pr.59 = " 2, 3"
ON
ON
ON ON
ON
. Turning OFF the RH signal stops increasing the
. When = "9999", the deceleration speed is
Pr.45
Deceleration to the
frequency lower than
the set frequency
Not available
When Pr.59 = " 1"
Time
ON
ON