Table of Contents
Advertisement
Parameterization
Submenu/parameter
Submenu
Fingerprint
Submenu
Transfer
84
Value range
Submenu
Fprt1
Diagnostic
AC volt. coil;
Value
AC curr. coil;
Ohm. coil res.;
AC volt. coil
Temp. coil;
Insul. coil res.;
Volt. E1; Volt. E2;
Electr. balan.;
Magn. linear;
SNR;
Max. DAC value;
Oprtg. hrs trn;
Oprtg. hrs sens
Data record
Current; Prod1;
Prod2; Startup;
Current
Factory;
Hist1; Hist2; Hist3;
Hist4; Hist5; Hist6;
Hist7; Hist8; Hist9
Submenu
As for Fprt1
Fprt4
As Product1
Accept
Yes, exit via C/CE
Yes → Enter
As Product2
Accept
Yes, exit via C/CE
Yes → Enter
Comment
Preselect the diagnostic measurement values that you
want to display and manage in the Fingerprint data.
Assign the rate for Fprt1. The display line for the process
indicator is assigned in the submenu.
Select the value:
AC volt. Coil:
AC curr. Coil:
Ohm. coil res.:
Temp. coil:
Insul. coil res.:
Volt. E1:
Volt. E2:
Electr. balan.:
Magn. Linear:
SNR:
Max. DAC value:
Oprtg. hrs trn:
Oprtg. hrs trn:
These values are updated only if the status was set to
Warning or Error in the "Alarm Settings" submenu.
Current: Data record for current value
Prod1:
Prod2:
Start:
Factory: Factory for Fingerprint
Hist1-9: Data record 1 ... 9 for the preceding
Assign the rate for Fprt1. The display line for the process
indicator is assigned in the submenu.
Import the current data record in a Fingerprint.
Copies the current data record in the Fingerprint "as
Product1".
Copies the current data record in the Fingerprint "as
Product2".
FSM4000
Coil voltage AC
Coil current AC
Ohmic resistance of coil
Coil temperature
Insulation resistance of coil
AC voltage at electrode 1
AC voltage at electrode 2
Electrode balance
Magnetic linearity
Signal-to-noise ratio
Max. DAC value
Operating hours for transmitter
Operating hours for flowmeter sensor
Product1-Fingerprint
Product2-Fingerprint
Startup for Fingerprint
measurements
D184B140U02
Advertisement
Table of Contents
