DencoHappel ZGF.1E series Operation Manual page 88

Safety and User Instructions
Group structure of the MATRIX 3000 system in combination with the MATRIX 2000 system
Network
88
A group may be formed using the MATRIX 2000 and MATRIX 3000 systems. The
Fig. 6-37 shows an example of a network consisting of a control panel,
MATRIX 2000 system, MATRIX 3000 system and various global modules.
Unit 16
Max.
1 control panel
Unit 1
Fig. 6-37: Combined group structure of controller types MATRIX 2000 and
MATRIX 3000
The group address is assigned:
via the group address switch on the control panel – refer to the "Commission-
–
ing and Testing" section in the relevant operation manual for DencoHappel
MATRIX ® control panels.
– on the printed circuit board of the MATRIX 3000 controller – refer to the unit's
operation manual.
Data assignment of MATRIX.LON module is performed via LON
tion. The MATRIX.V module is assigned to this group via the group address
switch – refer to the "Commissioning" section in this operation manual or the cor-
responding manual for DencoHappel MATRIX
Units 2 to 16 can be freely assigned. The control panel must be connected to a
MATRIX 3000 controller type
The MATRIX 3000 system permits the installation of a group, also with compo-
nents from the MATRIX 2000 system.
Besides, the control panel is not required if global modules, such as
MATRIX.LON, DI, DO, AI are installed, and the required operating parameters
and setpoints are communicated via these group modules.
Unit 2
4-7 wires 4-7 wires
Unit 2
4-7 wires 4-7 wires
® Global Modules.
PR-2011-0115-GB • Subject to modifications • R4-12/2015
Flex-Geko Fan Coil Unit
Group
Unit 16
Unit 16
®
-side configura-