DencoHappel ZGF.1E series Operation Manual page 83

Flex-Geko Fan Coil Unit
Fig. 6-26: Connecting inlet sensor
6.7.8 Connecting room sensor/return-air sensor (option)
Fig. 6-27: Connecting room sensor/return air sensor
Fig. 6-28: Connecting room sensor/return-air sensor
PR-2011-0115-GB • Subject to modifications • R4-12/2015
1
14
Pos. 1:
15
• Connect the inlet sensor according to the wiring
diagram.
• Connect the shielding of the sensor line with grounding
clamps to a large ground area!
Pos. 1:
•
•
Pos. 1:
• Connect the room or return-air sensor according to the
wiring diagram.
511 2001
Connecting cable (refer to notice on Page 77)
511 2001
Connecting cable (refer to notice on Page 77)
Connect the room or return-air sensor according to the
wiring diagram. The connecting terminals are located
on the mounting plate of the control panel (refer to the
operation manual for the relevant control panel).
With 2-pipe change-over units with MATRIX 2000 - the
connection of an additional room or return air sensor is
only possible via the AI module.
511 2001
Connecting cable (refer to notice on Page 77)
Safety and User Instructions
MATRIX
3001 4001 4001+IO
MATRIX
3001 4001 4001+IO
MATRIX
3001 4001 4001+IO
83