DencoHappel ZGF.1E series Operation Manual page 82

Safety and User Instructions
6.7.5 Connecting mains supply voltage for full electric heater
Fig. 6-23: Connecting mains supply voltage for full
electric heater
6.7.6 Connecting external sensor (option)
Fig. 6-24: Connecting outdoor sensor
6.7.7 Connecting the inlet sensor (option)
Fig. 6-25: Connecting inlet sensor
82
511 2001
Power supply 400 V AC / 50 Hz, fusing by others
Pos. 1:
max. B 20 A
Connection on terminal block
Pos. 2:
(e.g. with 5 x 2.5 mm
• Apply the mains supply voltage in accordance with the
wiring diagram.
511 2001
Connecting cable (refer to notice on Page 77)
Pos. 1:
• Connect the outdoor sensor according to wiring
diagram.
511 2001
Connecting cable (refer to notice on Page 77)
Pos. 1:
•Connect the inlet sensor according to the wiring dia-
gram (refer to Fig. 6-17 on Page 78). The connecting
terminals are located on the mounting plate of the con-
trol panel (refer to the operation manual for the rele-
vant control panel).
With 2-pipe change-over units with MATRIX 2000 - the
–
connection of an additional room or return air sensor is
only possible via the AI module.
PR-2011-0115-GB • Subject to modifications • R4-12/2015
Flex-Geko Fan Coil Unit
MATRIX
3001 4001 4001+IO
2
NYM)
MATRIX
3001 4001 4001+IO
MATRIX
3001 4001 4001+IO