DencoHappel ZGF.1E series Operation Manual page 115

Flex-Geko Fan Coil Unit
Control panel
1
Fig. 7-11: Set address on the control panel
Control panel, Flex-Geko(s) Group 0 (address 0)
Pos. 1:
Control panel, Flex-Geko(s) Group 1 (address 1)
Pos. 2:
Control panel, Flex-Geko(s) Group 2 (address 2), etc
Pos. 3:
PR-2011-0115-GB • Subject to modifications • R4-12/2015
The corresponding group address must be assigned to the control panels and
units in a group.
Single group (without networking multiple unit groups)
• On the control panel, set the address "0" (manufacturer's default setting).
• On the unit PCB(s), set the "0" address (manufacturer's default setting).
Networking multiple groups
• On the control panels and all unit PCBs assigned to the individual groups, set
the addresses to 0 -15. Each group is assigned its own address. The labels A
to F correspond to the addresses 10 to 15.
NOTICE!
Assigning duplicate addresses on the control panels can cause malfunctions.
The default setting for the group address switch is "0" and must be changed, if
required.
Unit circuit boards
2 3
511 2001
Group addresses
0 Group 0
1 Group 1
2 Group 2
3 Group 3
4 Group 4
5 Group 5
6 Group 6
7 Group 7
Safety and User Instructions
MATRIX
3001 4001 4001+IO
8 Group 8
9 Group 9
A Group 10
B Group 11
C Group 12
D Group 13
E Group 14
F Group 15
115