DencoHappel ZGF.1E series Operation Manual page 74

Safety and User Instructions
74
Fig. 6-11: Connecting cable and terminal block
NOTICE!
Depending on the MATRIX control system, different cables types with different
number of wires is used.
For unit-related assignment of terminals as well as data on cable type refer to
section „Electrical connection with MATRIX" on Page 76.
Run the low voltage and mains power supply cables separately at a minimum
distance of 150 mm.
For additional information on the control panel like changing mechanical limita-
tion of speed selection switch refer to the separate operation manual for the
control panels.
• Run the connection cable to the electrical control box of the Flex-Geko through
the opening in the mounting plate of the control panel (refer to Fig. 6-11) and
connect all wires to the terminals.
• For this purpose use a screwdriver to loosen the terminal (refer to Fig. 6-11)
and run the relevant wire into the required terminal opening. As soon as the
screwdriver is removed, the spring-loaded terminal will ensure the needed
grip.
PR-2011-0115-GB • Subject to modifications • R4-12/2015
Flex-Geko Fan Coil Unit