Configuring CLI support
Secure shell access
Enable this option to allow access to the CLI via an SSH session. The CLI supports SSH on
the standard TCP port (22).
SSH connections to the CLI can be made on any active interface. Support for each interface
must be explicitly enabled under Security on the Controller >> Management >
Management tool page.
The following SSH clients have been tested with the CLI. Others may work as well:
OpenSSH
Tectia
SecureCRT
Putty
Authentication
The CLI validates login credentials (username and password) using the settings defined
under Administrative user authentication on the Controller >> Management >
Management tool page (shown here for reference).
Local manager account
The login username and password are the same as those defined for the local manager
account. If this account is disabled, the last known username and password for this account
are used.
Administrative user authentication settings
The login username and password use the same settings (Local and/or RADIUS) as defined
for the manager account.
1-6