Snmp-Server Trap Destination - HP MSM765zl Reference Manual

snmp-server trap destination

Supported on: MSM710 E-MSM720 MSM760 MSM765zl
snmp-server trap destination <host> <[port number]>
Add a new trap destination.
no snmp-server trap destination <host> [<port>]
Deletes the specified trap destination.
Parameters
Sets the IP address or domain name of the host that the controller will send
<host>
traps to.
SNMP port number. Range 1 - 65535. By default port 162 is used
<[port number]>
snmp-server trap heartbeat
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
snmp-server trap heartbeat
Enables sending of heartbeat traps at regular intervals.
no snmp-server trap heartbeat
Disables sending of heartbeat traps at regular intervals.
snmp-server trap link-state
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
snmp-server trap link-state
Send a trap when the link state changes on any interface.
no snmp-server trap link-state
Do not send this trap.
snmp-server trap snmp-authentication
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
snmp-server trap snmp-authentication
Send a trap each time an SNMP request fails to supply the correct community name.
no snmp-server trap snmp-authentication
Do not send a trap each time an SNMP request fails to supply the correct community name.
snmp-server version 1
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
snmp-server version 1
Enable support for SNMP version 1.
no snmp-server version 1
Disable support for SNMP version 1.
CLI commands
Config context
2-29