Wireless Filters Rule Input - HP MSM765zl Reference Manual

CLI commands
Virtual AP context

wireless filters rule input

Supported on:
wireless filters rule input <rule>
Adds a custom filter definition for incoming wireless traffic.
Use this command to define custom security filters for incoming wireless traffic. Filters are
specified using standard pcap syntax (http://www.tcpdump.org/tcpdump_man.html) with the
addition of a few HP-specific placeholders. These placeholders can be used to refer to specific
MAC addresses and are expanded by the controller when the filter is activated. Once expanded,
the filter must respect the pcap syntax. The pcap syntax is documented in the tcpdump man page:
Placeholders
%a - MAC address of the access controller.
%b - MAC address of the bridge.
%g - Mac address of the default gateway assigned to the controller.
%w - MAC address of wireless port.
wireless filters rule output
Supported on:
wireless filters rule output <rule>
Adds a custom filter definition for outgoing wireless traffic.
Use this command to define custom security filters for outgoing wireless traffic. Filters are
specified using standard pcap syntax (http://www.tcpdump.org/tcpdump_man.html) with the
addition of a few HP-specific placeholders. These placeholders can be used to refer to specific
MAC addresses and are expanded by the controller when the filter is activated. Once expanded,
the filter must respect the pcap syntax. The pcap syntax is documented in the tcpdump man page:
Placeholders
%a - MAC address of the access controller.
%b - MAC address of the bridge.
%g - Mac address of the default gateway assigned to the controller.
%w - MAC address of wireless port.
wireless filters type
Supported on:
wireless filters type (mac | gateway | rules)
Sets the type of wireless security filter to use.
Parameters
mac
gateway
custom
2-104
MSM710 E-MSM720 MSM760 MSM765zl
MSM710 E-MSM720 MSM760 MSM765zl
MSM710 E-MSM720 MSM760 MSM765zl
Traffic is forwarded to an upstream device with a specific MAC address.
Wireless security filters use the default definitions.
Traffic is forwarded to the default gateway assigned to the controller.
Wireless security filters use the default definitions.
Lets you define custom security filters and address for the upstream
device.