Advertisement
MSM750 Controller Quickstart
C. Test the wireless public access network
Test the APs using a Wi-Fi-equipped computer:
1.
To ensure that you are using a wireless connection, disconnect any network cable from
the test computer.
2.
Configure your computer to connect to the wireless network created by an MSM AP. By
default, this network is named HP ProCurve.
3.
Log in to the public access interface as described in Test the public access interface on
page 5 and confirm that you can browse the Internet.
WIRELESS SECURITY: It is recommended that once the MSM750 is installed,
Caution:
you review the security information in the MSM7xx Controllers Management
and Configuration Guide and adjust the security settings to further safeguard
the wireless network from intruders.
6
© Copyright 2009 Hewlett-Packard Development Company, L.P. The information
contained herein is subject to change without notice.
HP ProCurve Networking
5992-6023
Advertisement
