Ip Nat Outside Source Static - HP MSM765zl Reference Manual

CLI commands
WAN IP interface context
This feature is useful when the controller is connected to the Internet and NAT is not being used.
Instead of assigning two IP addresses to the controller, one to the Internet port and one to the
LAN port, both ports can share a single IP address. This is especially useful when a limited
number of IP addresses are available to you.

ip nat outside source static

Supported on:
ip nat outside source static (tcp|udp) <visible-port> <internal-addr>
<internal-port>
Adds a static NAT mapping which routes the specified incoming traffic to the specified IP address
on the internal network.
Parameters
tcp | udp
<visible-port>
<internal addr>
<internal-port>
ip address alternate
Supported on:
ip address alternate <ip address> [<ip address>]
Assigns an alternate IP addresses to the Internet port. The address must be valid on the Internet.
no ip address alternate <ip address> [<ip address>]
Deletes the specified alternate IP address.
The controller uses these addresses to support its one-to-one NAT feature. The controller will not
respond to pings directed at these IP addresses:
2-96
MSM710 E-MSM720 MSM760 MSM765zl
Selects the protocol that the mapping will operate on.
The protocol port number that the incoming traffic uses.
IP address of the device on the internal network that traffic will be routed
to.
The protocol port number that the incoming traffic will be mapped to.
MSM710 E-MSM720 MSM760 MSM765zl